Fish Finder Transducer Mounts

Fish Finder Transducer Mounts

fish finder transducer mounts

A variety of fish finder transducer mounts exist for various types of fishing boats. This article will discuss the different mounts, including the Pedestal mount, Transom mount, Through-hull mount, and Side-mount. Using one of these mounts is the best way to install your transducer. But which one is best for your boat? It really depends on the type of fishing boat you own.

Pedestal mount

A Pedestal mount for your fish finder is a convenient, low-profile way to position your transducer. Its 6.5″ diameter and 4″ diameter round base offer a secure and waterproof mounting solution. The pedestal mount also provides tilt and swivel while providing added height and protection for the electronics. It is ideal for anglers who fish on the open water. This mount is available in various sizes and is highly recommended for use with a fish finder transducer.

When installing a pedestal mount, you must run power cables and then install the fish finder. Make sure that you allow enough room for adjustment. The leading edge of the transducer should be 1/8″ below the hull. If you find that the readings are too poor, try lowering it. It will help you to avoid tangles. If the mounting doesn’t give you good results, you can always adjust the height.

Transom mount

The most important thing to remember when choosing a fish finder transducer mount is that it must be positioned correctly for best performance. The transducer’s mounting surface should be parallel to the bottom of the boat, under the water line. Mounting the transducer too high will cause the transducer’s lower surface to be out of the water when the boat is on planing speed. The transducer will continue to operate properly at slow speeds under 2 mph, but will cease to work at higher speeds.

The mounting bracket should be large enough to allow for a lot of adjustment. In particular, the leading edge of the transducer should be mounted about an eighth of an inch below the hull. This can be done by lowering the transducer. If the transducer’s reading isn’t clear, you can always lower it to improve its position. Make sure that the mounting bracket has enough adjustment, as lowering or raising it will help improve the results.

Through-hull mount

Before you install a through-hull mount for fish finder transducers, you must thoroughly clean the transducer housing. Use isopropyl alcohol to clean it thoroughly. Then, you should apply epoxy to the transducer’s face and inside the hull. Press the transducer’s face into the adhesive using a twisting motion. To prevent any air bubbles, you can use tape to temporarily hold the transducer in place until the epoxy has cured, as instructed by the manufacturer.

Before you install a through-hull mount for fish finder transducers, you should know the boat’s deadrise angle, which is the angle of the V-shaped keel. You can measure this angle using a straightedge inside the hull or a carpenter’s square. Make sure to measure the deadrise angle from both the inside and outside hull. Then, match the measurements with the base flange of the transducer. When you have measured the deadrise angle, it should align with a line drawn inside the hull.

Side mount

The transducer should be mounted parallel to the water surface and under the water line. The best location is near the starboard side of the boat cockpit, as it is easier to route the cable to the cockpit. Make sure the power cables are not too long, as this could cause interference and tripping hazards. When you install the transducer, you must also make sure to place it away from other wires and electronic devices.

There are several types of mounting options for a fish finder transducer. Most come with a transom mount. They are easy to install and are made of materials that can be mass-produced. Through hull mounts are usually found on large vessels and sailing boats, and require minimal modification. However, this type of mount is not the best choice for every boat. To ensure that the transducer works properly, you should take measurements before buying.

Read our next article Small boat fish finders. We would love your feedback about our Kayaks