How to Install 2 Fish Finders on a V-Hull Boat

You may be wondering how to install two fish finders on a v-hull boat. In this article, you will learn how to install the devices. First of all, you need to locate the power source. You can do this by running the cables along the transom, above the transom, and under the hull of the boat. You must be very careful with the wiring, as too much slack can be a safety issue. Likewise, not enough slack will make the fish finder difficult to connect to the battery, and may cause the wire to come loose. gps fish finders for sale

Next, you need to prepare the mounting hole. You will need a power drill and fresh drill bits. You should also use masking tape to protect the fiberglass or gel coat. Before drilling the hole, it is a good idea to cover the area with masking tape to prevent any cracking or chipping. This step is crucial to ensure that the fish finder is properly installed. Afterward, you can begin using the fish finder.

Once you have the power source, it is time to mount the transducer. Before you install the transducer, you should align it with the running surface of the hull. Once you have done that, you can install the bracket by following the manufacturer’s instructions. Make sure you install the bracket with the correct height and position. The wires from the fish finders should be run properly. Depending on the type of fish finder, the wire may be difficult to install, so be sure to carefully follow the instructions.

If you are installing a transducer on a fiberglass hull, you must attach it to the jackplate or transom using mounts that go through the hull. The transducer should be placed in a deep area to reduce the turbulence. A spot that is too rough will result in a poor image and will not work properly. Therefore, you should not cut the wires of the transducer.

You may also want to consider installing a gimbal mount. These are great for raising the fish finder up and adjusting its angle. However, they will take up extra space that you can use for rod storage. Therefore, you should choose a mount that will allow you to do this without disrupting the rest of your helm. And remember that the more permanent solution is to mount the fish finders on the deck.

You should take note of that the installation process is far less complicated than many people think. In case you are a novice, make sure that you follow the manufacturer’s instructions carefully. Once you’re familiar with the process, you can troubleshoot any problems with the setup. But if you are unsure, a guide can help. And don’t forget to read the manual.

You can also use an in-dash mount for the fish finders. But you need to pay attention to the weight of the fish finder. If it is heavy, make sure that the mounting area is stable and strong enough to support it. If it doesn’t, you can install it overboard. Nevertheless, you need to learn the jargon of mounting your fish finders.