How to Install a Kayak Fish Finder

Before you install a kayak fish finder, it is vital that you know how to wire it properly. You must make sure that the wires are long enough and not too thick. It is also important to make sure that the wires are not too tangled. Too much slack can interfere with the wiring, reducing its performance and ruining the image quality. Fortunately, there are a few simple steps you can take to make the installation a breeze. top rated fishing kayak

Before attempting the installation process, you should know where you want the fish finder to go. You can either mount it on the kayak’s gear tracks or close to the cockpit. The transducer should be placed slightly higher than the bottom of the kayak, to ensure that a rock won’t damage it. Be sure to secure the cables with twist ties or clamps. Adding electronics is not without its downfalls, though. The largest drawback is the weight of the battery. Sealed lead acid batteries are heavier than lithium ion batteries.

Installing a kayak fish finder is fairly simple. Make sure that you install it with mounts on the transom. The transducer should be located at an unobstructed, deep spot in the hull, minimizing turbulence. The rougher the water around the transducer, the less accurate the readings. So, take your time and install your kayak fish finder correctly. You can learn more about installing a kayak fish finder below.

If you’re installing a kayak fish finder, the first step is choosing the right battery. It should be powered from a 12-volt battery, which is the easiest and most convenient power source on a kayak. Make sure the battery you purchase has a sealed lead acid (SLA) battery to prevent corrosion. Also, be sure to get a waterproof battery for your kayak fish finder. You can purchase marine-rated cables at your local marine chandlers.

If your kayak doesn’t have a transducer section, you can purchase a transducer mount. This mount will fit your transducer on a flat deck section, but may not fit in some kayak models. If this is the case, you can purchase an aftermarket mount that fits the transducer on your kayak’s deck, swing arm, or slide track. The aftermarket mount will have a smaller footprint than the stock mount.

Before mounting your transducer, you should determine how to mount it. While most transducers will work on your kayak, some are more efficient when mounted on the side or below the kayak. Mounting your transducer inside your kayak is much easier than mounting it on the side of your boat. You can use a puck-type transducer to see the bottom contours of the water and its depth. Once you’ve decided where to mount your transducer, it’s time to get a mount and connect it to your kayak.

The next step is to install the battery. Depending on the type of kayak you have, you can either place it in the hull or run the power cable through a hatch in the deck. Typically, a 12-volt battery will run your fish finder for days. Be sure to protect it with a wire cap or special battery box to prevent it from being damaged by the kayak’s movements. If the battery is inside the kayak, you must install a boat charger for it to work properly.