mounting fish finders on dash of bowrider

How to Mount Fish Finders on the Dash of a Bowrider

When mounting fish finders on a bowrider’s dash, you need to make sure the mount is securely fastened to the boat. The screws must be snug, but not too tight. You also need to make sure that the cables are properly attached and plugged into the power source. A simple yet secure method is to use cable ties or cable wraps. You can also use shrink tubing for wire splices. Don’t use electrical tape, though, as it is messy and doesn’t look professional. best fish finders on the market

One of the biggest challenges of mounting a fish finder on a bowrider’s dash is the lack of space. Unless you have plenty of room in the dash, it’s nearly impossible to install flush-mounted electronics. Fortunately, there are bracket-mounted solutions for bowrider dashes. Alternatively, you can install a transom-mounted fish finder instead.

Another way to mount fish finders on a bowrider’s dash is to purchase a gimbal mount. This allows you to raise the fish finder off the steering wheel and make it more accessible. This is a convenient option for bowriders that don’t have a large dash space.

Besides being easy to install, a RAM mount is convenient for frequent updates. It can be mounted in the center of the steering wheel or above it. The best angle for a fish finder is waist to shoulder high, whereas an overhead mount forces you to crane your neck backwards, which can be dangerous. Also, you must choose a mounting location that allows you to tilt the display and turn it when you want to.

Pedestal mounts are also an excellent option for smaller boats. These mounts are between one and four feet tall, and extend from the deck of the boat. Most pedestal mounts are durable and sturdy, but make sure you remove the fish finder while traveling. This way, you won’t have to worry about the locator wiring.

While flush mounts are the most attractive option, they aren’t always the most functional solution. You might want to use a gimbal mount if you have the space. However, this isn’t a good solution if you don’t want to deal with potential damage caused by objects.

You may also want to consider a portable mount. These are convenient for moving from one boat to another. Some portable mounts even come with a removable arm. These are good for temporary installations, but it’s important to make sure you choose a sturdy, easy-to-use mount. If you don’t have the luxury of changing mounts, you can also choose a suction cup mount.

It is important to remember that a fish finder can’t work without a transducer. The transducer’s position affects its performance, so make sure to select the right location. The best location is near the transom, between an eighth and one sixteenth inch below the bottom of the boat. If the transducer is too high, the water will get under it, and the transducer will lose its bottom reading.