How to Smooth Out Scratch on a Polyethylene Kayaks

Polyethylene kayaks are made of plastic, so you’ll need to repair any surface scratched by frequent use. Use progressively finer sandpaper to remove scratches. This will smooth the hull by removing shavings. You can also use a hammer to apply a filler to the scratched areas. Repeat the process as necessary until the scratches are gone. fishing Kayaks for sale

If you’re unsure of how to smooth out scratches on your polyethylene kayak, try using a heat gun. You can purchase a ‘razor scraper’ on eBay or Amazon for less than $20 USD. Gently glide the scraper over the scratched area until the plastic disappears. If you’re dealing with a deeper scratch, use a marine-rated gel coat instead. Use the correct safety equipment and follow all instructions before applying gel coat.

Once you’ve found the scratch, you need to make sure you don’t damage the kayak. If the scratch is small, you can use a sandpaper with a finer grit to smooth it out. Make sure you follow the instructions carefully and avoid damaging the kayak. Make sure you don’t burn the polyethylene kayak. This can be very dangerous. Always wear protective gear while kayaking, and always wear a paddle and life jacket.

If you’ve gotten a scratch on the bottom of your polyethylene kayak, it’s inevitable. Using it for regular activities will eventually cause some scratches. Although most of them are cosmetic, they can also reduce the efficiency of your paddle strokes. Scratches will cause your kayak to slap into the water and won’t glide as smoothly as it should. So, if you’ve noticed a scratch on your polyethylene kayak, it’s time to smooth out the surface to prevent it from getting worse.

If the scratch is on the top of your polyethylene kayak, you can fix it by washing it with a garden hose. However, it won’t remove any of the surface damage. Instead, you can use silicone or duct tape to repair the cracks, and the silicone will keep water out. However, if the scratch is on the bottom of your kayak, you’ll need to spend more time repairing it.

If you’re unable to remove the scratch with a plastic spoon, you can try applying FSR directly on the damaged area with a small brush. However, you should use care because the heat produced by the FSR will cause the polyethylene to deform. You should always use protective gloves and try to avoid flammable surfaces. And be careful not to burn yourself while applying FSR.