The Best Way to Set Up Fish Finders in a Boat

There are several ways to install fish finders in a boat. One of the best ways is to use a transom mount. This way, the transducer can be installed in an area that is deep and free from obstructions. Moreover, a transducer can give better performance if it is not in a spot where the turbulence can affect its performance. small fish finders

Another common method is to use the touchscreen on a fish finder. Touchscreen devices are easier to use than older versions, as they are similar to the experience of using a smartphone. However, fishfinders with buttons are easier to use when driving a boat or in unsteady waters.

Another option is to mount the fish finder under the console. This way, the device is easy to see from the cockpit. However, there are several things to consider, including the distance to the terminals and the power supply. Make sure that the cable is long enough to go from the transducer to the console.

Once you have decided on the mounting location, the next step is to drill the holes needed for the fish finder’s wires. Ensure that there are no obstructions behind the mount and allow access to the wire. Once you have drilled the holes, you can seal them with silicone sealant to keep the wiring from coming out.

Once you have the right spot, mounting the fish finder is easy. It is best to have a professional install it. This is the most common way of installing fish finders on boats. A transom mount is a great choice for smaller fishing boats. However, you should keep in mind that the transducer can be interfered with by propeller bubbles.

The next step is to secure the wires of the transducer. The wires should be secured with small wire clamps at every foot. The wires should not be bundled with the VHF cable or the engine wiring harness. This can cause interference, which decreases the performance of the fish finder.

When you are using the fish finder, you should move slowly. A quick movement will lead to an unstable image. Also, you should make sure that the transducer is not too high or too low. This will cause the reading to cut in and out. You can also adjust the transducer’s height.